General Guide of Shower Pump

General Guide of Shower Pump


A shower is always a daily use thing. We will attend to them everyday at our home. As such shower setting becomes more develop follow the progress of technology and skills. If your shower performance is poor, you can increase the water pressure by either raising the storage tank or installing a pump. For instance a proper, powerful shower pump is an absolute necessity. This is because of everyone like me and you have to admit that it’s not the same as a nice, long, hot bath.

Manual Shower Pump

Manual shower pump like shower waste pump and single shower pump is relatively easy to install and apply. However their function is limited. In another word, they must be independently supplied with hot and cold water. These shower pumps are seldom find in city now as more people moving towards using modern and power shower pump like salamander shower pump and monsoon shower pump. Manual shower pump is inflexible in terms of application and function switching. They must be independently supplied with hot and cold water. The single lever controls both the temperature and flow of the water.

Modern Shower Pump

Modern shower pumps like Salamander shower pump and Monson shower pump are basically the same as manual mixers except that they have an in-built safety device to prevent scalding or freezing. These shower pumps performing consistently whether it’s the cold or the hot water flow rate that drops. Moreover the mixer of this power pump will automatically compensate, by reducing the flow rate on the opposite side. This wonderful features and settings have effectively prevents an accident if somebody turns on a tap elsewhere in the house or flushes the bathroom.

Shower Pump – Installation

Majority of the shower pumps can be used with existing gravity-fed hot and cold water supplies. However it is provided if you may need to fit a booster pump. You must double check with your supplier as some showers work well at low pressure.

In general for the installation for a shower pump, you need to first get cold water supply. Thus once you get your supply for your cold water, you can proceed for gating and draining the shower valves. As far as concern, the best position for these shower pumps, if possible, is next to the hot-water cylinder, normally in the airing cupboard. As these pumps are not silent, you may want to insulate the cupboard for noise. When installing the pump, remember to install it at the bottom or below the cylinder to ensure it always remains full of water.


Leave a Reply

Your email address will not be published. Required fields are marked *